top of page

Thank you for downloading WinBidPro

What's new in version 16.8.7

Improvements:

  • The entrances tool tab now shows better messages about validation problems or missed steps when adding an entrance.

Bug fixes:

  • Since 16.8.0, reports were always rounding to 16ths in fraction mode, even when a 32nd adjustment was applied to a cut. Additionally there was a related issue where cuts would show up as 0" when 31/32 rounded up to a whole integer.

  • Door leaf components allowed alternate assemblies to be specified but this is not actually supported for door leaves

  • Fixed a crash scenario in the panel tool tab when there is no active elevation tab

  • Fixed a crash scenario in the entrances tool tab when there is no active elevation tab

  • The quick filters were not always sync'ing correctly with the filter controls of the Door and Door Frame table headers.

  • Creating a new entrance showed a validation error when first opened.

DSC01882.JPG
bottom of page